Close filters
 
  •  
  •  
No results were found for the filter!
needle holder_1 Hush Shielded Electrode Cable
Shielded Cable for Dantec DCN Electrodes. Cable fits most EMG instruments. Length Electrode End Instrument End 1.5 m pogo pin 5-pin DIN
cable 9013C0132_9013C0112 Multi-Use EMG and IOM Cables
For use with Adhesive Disposable Pre-Gelled surface electrodes Scalp needle electrodes Natus Sensory needles Shielded Cable 1/pkg Unshielded Cable 8/pkg Length Electrode End Instrument End Quantity 1 m 2 x 0.7 mm female touchproof 5-pin DIN 1/pkg 2 m 2 x 0.7 mm female touchproof 5-pin DIN 1/pkg 1 m 3 x 0.7 mm female touchproof 5-pin DIN 1/pkg 2 m 3 x 0.7 mm female touchproof 5-pin DIN 1/pkg 0.8 m 0.7 mm female touchproof 1.5 mm female touchproof 8/pkg 2 m 0.7 mm female touchproof 1.5 mm female touchproof 8/pkg
Alligator clips 117-401900 Alligator-Clip Lead Wire Sets
– Lead wires terminate in 1.5 mm touchproof connectors – Designed for use with disposable tab electrodes without lead wires – Compatibility: Most EMG systems Type Quantity Complete Set 1 set/pkg red / black pair 1 pair/pkg Ground 1/pkg
9013C0232 HUSH Alligator Clip Cables
– For use with pre-gelled tab electrodes – Cable withstands >50 lb pull test – Compatibility: Most EMG systems Type Lenght Electordeend Instrumentend Shielded 100 cm 3 color-coded clips (red, green, black) 5-pin DIN Unshielded 80 cm Clip Connector - green 1.5mm touchproof connector Unshielded 80 cm Clip Connector - red 1.5mm touchproof connector
JUMP26261_V1-1 Jumper Lead Adaptercable
Electrode side: 1,5mm DIN socket Device side: 1,5mm DIN connector Cable length Color 15 cm black 15 cm red 15 cm green
KS26DIN_V1-1 Extension cable 1.5mm touchproof
Suitable for any equipment with 1.5mm TP connectors Touch Proof Ø 1,5 mm DIN 42802 1.5 mm TP to 1.5 mm socket Pack of 10 cables with mixt colors Different lengths and connectors available upon request Cable length 50 cm 100 cm 150 cm 200 cm 250 cm
#070 Needlecable
This multifunction cable can be used with needle electrodes from our "MYOLINE" needle program and with the stimulation / recording electrodes from our EMG multifunctional system. Cable length 100cm 200cm
HUSH_yoke_cable_9013C0302 HUSH Yoke Cable
Converts 2mm connectors to touchproof connectors Converter cable: Plug directly into a safe 5-pin 240° female DIN connector; then plug any touchproof electrode into the three jacks or DIN Fully shielded to reduce artifact Electrode End : Three 1.5mm male touchproof connectors (red, black, green) plus a female 5-pin DIN Compatibility : Most EMG amplifiers Length Instrument End 1.5 m 5-pin DIN - Right Angle 1.5 m 5-pin DIN - Straight 0.1 m 5-pin DIN - Straight 4 m 5-pin DIN - Right Angle
Viewed

Help

Top